To further widen the range of pallet-wrapping systems, Italdibipack Group has introduced a NEW pallet-wrapper that functions electrically (compressed air is not required) and is equipped with an exclusive cut and clamp device PAT so that the stretch-wrapping cycle is fully automatic.

 The wrapping cycle starts and ends at the top of the pallet; this uniquely different approach to attaching and cutting the stretch-film provides the following advantages: 

•  Selectable top banding capability 
• Stabilizes the load early in the wrap cycle
• Places the ending film tail at the top of the load instead of the bottom 
• Eliminates the need of a film clamp power source on the turntable (therefore less maintenance; no need of compressed air with hook-ups or noisy compressors) 
• Easier, faster and safer positioning of the load on the turntable (no clamp or other systems that can be damaged)

   MAIN FEATURES:

• Working functions and operations controlled by a PLC, with touch-screen Operator Interface
• Power Off / On – Reset switch and Power-On indicator light
• Single button Auto Wrap cycle Start/Pause         
• Machinestatus visual indicator (run; clear or fault)
• Selection among three (3) different types of wrapping : automatic / semi-automatic / top banding
• Photo-eye for the automatic load height detection
• Separate setting of the top and bottom wraps, from 1 to 12 revolutions;
• Variable turntable speed control (adjustable from 3 to 15 rpm), with a soft start acceleration and a final revolution deceleration with positive stop alignment
• Film tension control
• Broken film/run-out of film detection with automatic machine reset     
• Separate film carriage raise and lower speed controls  
• Film carriage Lower/Raise buttons  
• Film carriage with an adjustable speed motor and driving through a belt/pulley with Anti-Fall Device.   
• Pre-stretch film carriage (max film width of 500 mm) with a 200% fixe ratio (1 mt = 3 mt), powered by a variable speed motor, with a fully electronic dynamic dancer corner compensation
• Carriage descent obstruction shut-off device for additional safety
• Side mounted film carriage for operator convenience and safety
• Turntable inserted in a square-shaped frame and supported by a 36 roller bearing system (direct chain driving system, with chain tensioner)
• Button for the manual control of the turntable rotation
• Predisposal for lifting the machine (with a fork lift) from the front and from the rear side (holes in the basement frame)
• Heavy duty frame with structural steel construction and Electro-static powder coated paint finish
• Emergency Stop Button

   Machine manufactured according to CE rules